Autoquip Tilt Table

Request STE Quote

Autoquip Upender

Autoquip’s 90-Degree Hydraulic Tilters utilize double-acting hydraulic cylinders to both rotate and return a load or container through a 90-degree travel at a controlled rate of speed. The hydraulic power unit is located inside the tilter base frame or can be remotely located.

Limit Switch

Limit Switch

Limit switch, and mechanical stops, in both directions prevents overuse of the motor, extending its life cycle.

Reinforced Deck

Reinforced Deck

Steel-reinforced platform minimizes deck deflection, maximizes load stability, and greatly extends its life.


STE-90-0202,000 lbs24" x 38"54" x 54"8"750 lbsQuote
STE-90-0404,000 lbs24" x 38"54" x 54"8"800 lbsQuote
STE-90-0606,000 lbs30" x 38"60" x 54"8"850 lbsQuote
Capacity2K lbs4K lbs6K lbs
Min Top24" x 38"30" x 38"
Max Top54" x 54"60" x 54"
Weight750 lbs800 lbs850 lbs


  • Tilters keep work within the ergonomic “power zone” and reduce fatigue and back injury by minimizing reaching and bending while loading and unloading bins and baskets.
  • Joints, the most critical wear points in the lift, feature chrome-plated, 100,000 psi, ultimate-strength pins for premium load strength and long life.
  • Minimum 1/4-inch-thick steel-reinforced platform minimizes deck deflection, maximizes load stability, and greatly extends the life of the platform deck.
  • Standard controls are prewired and drive unit is already onboard. Installation only requires the tilter to be lagged to the ground and connected to electricity.
  • Minimum 3:1 structural factor of safety makes these lifts the most structurally sound in the industry.
  • Chrome-plated rods improve durability extend the life of cylinders and seals.
  • Exceptionally low lowered height allows greater on and off load flexibility.
  • Maintenance-free bearings at pivot points require no lubrication.
  • On-board maintenance devices enable maintenance crews to safely and effectively block open the tilter during inspection and routine maintenance.
  • Sturdy, semi-transparent polyurethane oil reservoir provides an easily visible method of checking fluid levels and eliminates oil contamination due to rust.
  • Double wire braided Parker hydraulic hoses resist wear, abrasion, and leaks.
  • Hydraulic velocity fuses completely stop lifts in the unlikely event of uncontrolled descent due to sudden hose rupture.
  • Steel support in upper and lower frames provide additional structural rigidity and resistance to twisting and bending of the tilter under load.


  • "V" Craddle
  • Remote Power Units
  • Electric Toeguards
  • Foot Operated Control
  • Accordion Skirting
  • Conveyor Tops
  • Ball Transfer Tops
  • Limit Switches
Copyright 2022
All Right Reserved
Solution Dynamics, Inc.
T: 877-860-3620
P: 262-521-5730
F: 262-521-5733
GSA Logo
MHI Member
MHEDA Member
Solution Dynamics, Inc BBB Business Review